Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
According to the documentation, the management interface should be left untagged (0) when connecting over an 802.1q trunk configured for native vlan 1. When I do this, the management interface does not show up on the network. If I leave the switch si...
Looking to upgrade my 802.11b setup of original AP4800e's and 340's. I've settled on the 1130, and I would like to get a WLC appliance, but do I need to get the WCS too?
similar setup here...PEAPRADIUSSecurID tokensOdyssey 4.74402 4.1.171LAP1131WPA/WPA2 TKIP (no CCKM)Clients roam just fine, no need to re-authenticate. Using 4.1.171, but without the credentials caching or CCKM,
Had a similar problem with LAG on my 4402 connecting to a 6500 with CatOS. The TAC solution was:1: Ensure you are performing IP src destination load balancing across the port-channel to the WLC, with the command - set port channel all distribution ip...
I use the lightweight solution with 1131ag and 4402 WLC, but the basics are the same. You need a client supplicant that can do one time use tokens. The windows zero configuration client does not support one time use tokens. I use the Juniper Odyssey ...
