Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Everyone,
We have deployed two cisco virtual FTDs on our environment and configure them as HA. Those firewalls are connected with core switch over ospf and they are working seamlessly. However when the standby unit become active it will lose t...
Hi,
I am trying to upgrade FTD 2110 from 6.2.1 to the updated version. However i am not be able to download the required image. Is there any one who can share the images with me?
Thanks in Advance!
My cisco C9200L-24P-4G-E V02 console is showing unreadable words. Recently its IOS was deleted accidently and when i am trying to access it via console port it is responding unreadable things. Please note that the console and terminal emulator is wor...
Hi Guys
We have two FTD on environment which have been controlled by FMC. But currently the license is expired and i am facing an urgent configuration on the FTD. Therefore is this possible to use CLI interface?
Appreciate your support !!!
With Rega...
Hi
According to the 9800 WLC datasheet each access point should have a DNA subscription to connect with the controller. Also from the APs datasheet, each access point should have a DNA subscription while it is ordered and it's essential and advantage...
Hello MHM,
Like i said before changing the active unit the firewall is connected with the core switch over ospf protocol. Then we would like to change the active unit to standby by shutting down or reload it. By that time the standby unit will become...
