Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm running into an issue with a L2L VPN we have between one of our remote sites. At times one of the many networks there will stop passing traffic across the tunnel. Other networks at this location will continue to traverse the tunnel just fine when...
I'm currently running 6.3(5) on our PIX and am having some issues with a L2L VPN with a Juniper device. I've worked with both CTAC and JTAC to make sure the settings are correct on both ends. CTAC recommends that I upgrade the PIX to 7.2 and I was wo...
I have a L2L VPN between a PIX (6.3.5) and Juniper. On the PIX side I have 5 networks and on the Juniper side there are 6 networks. All is well most of the time, however, randomly a network will become unreachable. Other networks at this location ar...
I have a 6509 running native IOS 12.2 and for some reason the arp table is almost empty. I also have a couple of 7206 routers on the same network (connected to the 6509) that have a full arp table like I expect to see on my switch. This is the first ...
I'm just dipping my toes into PBR so bear with me here.Essentially, I am tying to route traffic from one remote office, through a data center (via a dedicated DS3 link)and out to the internet from there. I'm hopeful that the configs below will work a...
Ahhh...that explains what I'm seeing. I am using one of the 7206's as the default gateway for internet access and the other as the gateway for traffic coming back to our office.Thank You Giuseppe for clarifying that for me.
You are correct, I pulled some addresses out of a hat and tossed them in the mix to protect the innocent. I am thinking that the PBR would be done on the Cat6509. Since it would have a default route pointing to 2.2.0.1, which is fine for the product...
In this particular case that will work fine as I have access to both ends of the tunnel. However, if I had no access to the other end, like if it were a contractor. How would I protect myself from something coming into my network across the tunnel fr...
site A has a PIX running 6.3(5)I already have an access-list associated with my inside interface. I was thinking I could put it there, but wasn't sure.So I could say:object-group network DB_Serversnetwork-object host 2.2.2.3network-object host 2.2.2....
Hi Simon,What I've done is cosolidate a stack of switches (a few for our production environment and one for our coporate side) into the one core 6509. Each side, corporate and production, have a seperate firewall and internet connection. On this 6509...
