About jmanas

jmanas · 06-01-2023

Hello forum,I'm having problems to get the values of Tx and Rx optical signal on a Cisco 4500usually on other models using the command "show interface transceiver detail" will give all the info needed, this switch however is more modular, at the mome...

jmanas · 05-24-2023

Hello everyone,We bought some refurbished Catalyst 3750, and in one of them when you issue #show interface description, it shows 24 ports normally, but also shows another 24 Fastethernet ports.the IOS image is c3750e-universalk9-mz.150-2.SE11.bin and...

jmanas · 06-01-2023

I paste some of the relevant config:Cisco IOS Software, Catalyst 4500 (cat4500e-ENTSERVICESK9-M), Version 15.1(2)SG8, RELEASE SOFTWARE (fc2)System image file is "bootflash:cat4500e-entservicesk9-mz.151-2.SG8.bin"#sh inventory | i NAMENAME: "Switch Sy...

jmanas · 05-25-2023

Hello @Martin L,what a detailed step-by-step solution, thank you very much!, just had to do the first part, deleting the startup config file, the list now only shows the interface range Gi2/0/1-24Thanks again

jmanas · 05-24-2023

Thanks for taking the time to answer @Martin , not sure if this is what you wanted me to post:SW_Backup#sh int desInterface Status Protocol DescriptionVl1 admin down downVl100 up down ## Gestion SW ##Vl505 down downFa0 admin down downFa1/0/1 down dow...

Member Since	‎04-04-2023 03:00 AM
Date Last Visited	‎07-21-2023 12:02 AM
Posts	5

User Statistics

User Activity

Trouble getting signal value from sfps on switch Cisco 4500

Getting rid of an old module interface listing on a Catalyst 3750

Re: Trouble getting signal value from sfps on switch Cisco 4500

Re: Getting rid of an old module interface listing on a Catalyst 3750

Re: Getting rid of an old module interface listing on a Catalyst 3750