Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have recently purchased a Catalyst 6503 switch with Supervidor engine 32 and two 49 GigE blades. I have configured L3 switches before, but I am having an extrememly hard time routing my VLAN interfaces. I am even beginning to question if i did ac...
About two months ago my acct purchased a cisco IPS 4240 appliance. yesterday i was finally able to get my hands on it and configured it using the console. however, even though I can ping the sensor, i cannot telnet or use the webserver on it.telnet...
i have two subnets. currently i am using a /30 on the switch. this is the configuration on the other side. when i plugged it directly into the firewall, i was using a /28 with the gateway being the switch/router on the other end of the TLS. i thi...
I will contact them to get this information. however when i connect the circuit directly to my pix firewall, everythign works. the only reason i cannot do this is because of the failover appliance. this is why i was trying to use the router featur...
I agree. I should be able to do this all at layer 2, however, even with VTP configured and the VLAN configured, I have not been able to just have the two ends talk to each other. The other Network administrator is using a Layer 3 switch with VLAN34...
Rick,on the other end of one of those ports will be a another router the other half of a /30 subnet. within the router module of my switch i created a vlan 34 with my half of the /30 subnet. the other two ports will connect to a pix 515e fw w/fo. ...
Rick and Edison, thanks for the input. i should have put a little more information. this switch currently has 2 VLAN's. However, i do not want these VLAN's to talk to each other at all. What I have done is assign 3 ports to to VLAN 34 and i want ...
