Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have two PIX 515 firewalls in failover configuration. If I unplug the active unit from the network, failover occurs as it should. However, if I turn off the active unit, no failover occurs. When I turn the active back on, failover occurs to the sta...
Today I started setting up in my lab a network with redundant Cisco 2970 switches. The hosts are two HP DL145 servers with two broadcom GBe NICs. The systems are running Linux 2.6.15.1 and I have enabled bonding in the kernel as a module.Each NIC is ...
Disabling the lan based failover with the following command sequence fixed my problem:no failoverno failover lanfailoverI had to run this on both units so that configuration syncronization could continue.Thanks to Kris at TAC for his assistance!
