Hi,I have problem with waas on a WAE-512 appliance. nothing is displayed when I connect on console port. I've tried everything and nothing. I've put the recovery CD but nothing as well seams like it is not arriving to the CD boot step.When I open the...
Hi,I've got two Cisco 2811 routers on my lab with IOS 12.4(20)T. I try to do a simple NTP configuration R5 as NTP server and R4 as NTP client. R4 and R5 are connected by frame-relay.here are the configurations:R4:interface Serial0/0/0ip address 155....
Hi all,Please I'm searching a way to fix the disk space reserved for statistics and no way to find it.I would like to know for exemple how to setup up statistics data to not exceed 20% of disk space or something like that.I don't finf the path to do ...
Hi,I'm asking my self a question, How does waas handle the cookies for http trafic?Is there any session persistance mecanisme?Is it transparent so handle by the browser as usual?Is it cached?I would like to know hows does it work exactly.RegardsKarim
Hi,I think it is a hardware failure as well. The problem is that I have three appliance with the same problem. They use to work properly an than they were on warehouse for a year. I recently, I've checked there situation and when I power on anyone of...
Hin nothing on the screen and the led beside the flash memory is always red. When I power on the appliance it appear orange and than few seconds and it become red.Regards,Karim
Hi Giuseppe,My situation is not exactly like that.I have one ABR with two links to one ASBRR1 --- R2 ===== R3R1 and R2 have one link in area 0.R2 and R3 have two links between theme on area 1.The only interfaces on R3 that participate in OSPF are the...
Cisco Catalyst 2950 is a layer 2 switch. In order to allow your vlan to communicate you need to have either a router or a layer 3.this will allow you to activate inter vlan routing.Regards,Karim
