Hi everyone,I'm unable to access the interface of cisco asa from a vlan which is present on the router connected below. Packet-tracer shows no route to host.
Hi , I'm trying to connect a cisco asa 9.8 version in GNS3 to a router and the ASA doesn't reply to the arp requests by the router which is directly connected to it. Any help?
Thank you guys I'm able to figure out where i was making a mistake. I ran into issue now where i have created two vlans on R3 as 192,168.1.4 and 2.4 and 1.1 and 2.2 on R2. The link between R2 and R3 is trunk. I'm able to reach 192.168.1.1 from R1 but...
I can see that dropped blocks in arp are increasing is there any way to find out the reason, I did packet capture on arp entries with ethernet type set to arp but i don't see any dropped packets i can only see that router is sending an arp request bu...
