Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi I am trying to create an access list and I keep getting a syntax error on this command:access-list 1 deny 10.10.10.0 0.0.0.255 10.10.20.0 0.0.0.255 ^The error marker is on the start of...
Hello I was trying to set up two sites with a router at each site. There is a layer 2 switch that is connected to each router and they are connected to hosts. I set up a gre tunnel between the routers and set up ospf between the networks. There are a...
Hey thanks for the reply. I had another question. Is it possible to segment the networks so that 10.10.20.x can communicate only with 10.10.200.x and 10.10.10.x can only communicate with 10.10.100.x?
