Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hi,i try to configure a cisco 827(configure with nat) for ip nat traversal . a vpn client behind this router can establish a vpn connection to remote pix.but i can't ping any device behind the pix (doing also nat).here my configuration on the cisco r...
hi,i try to configure a pix 515 to accept dynamic connection from remote clients and remote cisco ios routers (with dynamic ip).i have no problem with the clients but i can't establish a tunnel with the routers.here is my configuration file on the pi...
i use a vpn client 3.6.4 behind a cisco 827 (ppoe with NAT) to connect to a pix 515 (configure also with nat ). I want to access a sever behind the pix.Can i configure ip nat traversal on the cisco 827 (ios 12.2.13T) ?does it work ?vpn client 6.3.4<...
I can establish a remote ipsec connection to my cisco 827 (pppoe and NAT) using client 3.6.3 (dialup) but i can't ping or session any workstation beyond this NAT router. My ios version is 12.2.(13)T.please help; here is my config:version 12.2no pars...
Hi,you have to use only "one" crypto map per interface .you cannot use both my_bad_crypto_map and my_working_crypto_map on interface E0.don't change "my_working_crypto_map" just increase the sequence number :replace the line : crypto map my_bad_cry...
hi,yes, you can configure router to router ipsec vpn.have you dynamic or static ip address ? read this cisco page : http://www.cisco.com/warp/public/707/ios_804.html
