Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I've got a simple NAT router. Fa0/0 is outside and Fa0/1 is inside. Inside network is 172.16.1.0/24. Outside network is a single dynamic public IP assigned from the ISP. I'm trying to implement a "Deny by Default" rule set that denies all inbound tra...
Hi there... I don't consider myself a Cisco expert or anything, but I can get around. I'll give an overview of my current setup... I currently have a Cisco 2621 powering a network at our co-location facility... It's a simple setup and is working w...
I'm moving into a newdatacenter. I don't consider myself a network engineer or anything but I do understand the basics. The new data center I am moving into routes mynetwork to me a bit differently than my old data center, so I thought I'd post here ...
I bet your going to say because only tcp, udp, and icmp can be stateful, just a guess this isn't what I'm an expert in Sent from Cisco Technical Support iPad App
Nice that worked well... Any reason I wouldn't do:ip inspect name FW ipaccess-list 101 deny ip any anyint Fa0/0 ip inspect FW out ip access-group 101 inJust curious. Thanks so much for your help, didn't know about that inspect function.Sent from Ci...
No worries at all! I saw that table before and made the assumption that if the value to the right was blank it meant it was the same as the column to the left, bad formatting but I'm glad it looks like everything will work out for me.As always, I app...
