Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Team,I was trying to upgrade Cisco IOS XE Software, Version 17.08.01 to Version 17..11.1. However the upgrade process fails and shows the following error message.switch# install add file bootflash:cat9k-wlc.17.11.1.SPAinstall_add: Adding IMG/fl...
Haha... It got fixed now Leo. The steps are belowChanged CONFIG_FILE variable = bootflash:packages.conf from rommon modecommand= unset CONFIG_FILE variable = bootflash:packages.confBooted from USB using stable image from rommon mode (command# boot u...
Hey Leo, We managed to upgrade the image, however it was not able to join stackwise virtual domain. It continuously reboots when we try to join to an active stackwise switch and enter to rommon mode. FYI, below there is #show boot command results for...
Thanks Joseph,I was looking to a datasheet and I found out that either of the two ports work as a data port not both, but not recommended as you said since the performance would be affected.N.B, the management port network will be in different routin...
Hi All,I have one question which I think it's related to this topic. Is it possible to use a management port as a data port? We have ordered Sup Engine 9600X SUP-2 which has 2x 10G SFP+ management port. Is it possible to use this port as a data port ...
