Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have a Pix 515E that was installed last November and in just the last 5-7 weeks we have been noting a massive speed decrease on through put. After much trouble shooting it turns out to be the Pix causing the problems.Example if issue: network loo...
I have configured my port-channels on my cat as follows:SwitchportSwitchport trunk encapsulation dot1qswitchport mode trunkThere are 3 gig ports connecting my HP Procurve switch. My HP will automaticly put them in a trunk group. My problem is when ...
We just got a Cisco 4507 Cat. Since I couldn't get enough to replace my HP 4108gl switches I will be using the Cisco as the head switch. We have been a flat network and now are going to vlan's. I have two questions I need help on.1. How do I get th...
After correcting the speed and duplex issue, which I should have looked at before, I did some testing.I'm still not getting that good of a pass through on my pix. If I connect to the segment on the outside of the outside interface and FTP a file I a...
I did just note something as I was crawling through the show tech that I didn't note before. Note the Output errors on both sides of my Pix. That is strange.Interface Ethernet0 "outside", is up, line protocol is up Hardware is i82559, BW 100 Mbps ...
We upgraded to OS 7 about 2-3 weeks ago so that our VPN clients could access the server over the Point-to-Point VPN tunnel with our other office. But the problem started before that, but has gotten a little worse after the upgrade(it seems).Accordin...
I think I have the port bonding issues resolved. My problem is I still have not gotten the vlan's to talk to one another from Cisco to HP. You said something about using LACP on the port but I was wondering about GVRP. The HP uses GVRP between the...
