Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello all,I have set up DNS on my cisco3640 for all dial in users with the following commands :ip domain-name mydomain.localip name-server 1.1.1.1when i dial in i can see that my laptop picks up the dns server address but i still have to type the ful...
Hello all,I use isdn for maintenance and backup links and i have noticed recently that if i 'sh int bri0/0' when the lines are up the available bandwith is much less than either the 64k or 128k i would expect. For example when i use one b channel i w...
Hello all,I have recently purchased an adsl wic for a cisco2600 router. As a consequence I have been forced to a buy an ip plus feature pack to support this device. The new ios is 16.6mb and my onboard flash for this standard 2620 router is 16.3Mb. T...
hello all,i am wanting to do some network performance testing by checking peak load bandwidth across my switch ports.Is there a way i can monitor and log multiple switch ports ? I believe monitoring one port can be done but can i monitor multiple at ...
Hello all,I have recently purchased a cisco 2600 and an adsl wic (wic1-adsl). I am have big problems getting the adsl wic to work.The background is :cisco ios : 12.2(8)T10When i install the card i cannot see it in the running config and i see bad buf...
Hello,thanks for the reply, I will try this out.Does this mean that the interface was only running at 48kbps or was it running at 64kbps none the less?if it was running at 64kbps anyway what is the point of the available bandwidth 48kbps line in 'sh ...
thanks to all for your responses.if i use the ios mentionned above will i be able to both install and use an adsl wic and fit the image in the 16mb flash. is this a viable alternative to having to upgrade the router ?thanks
Thanks again for the reply,i have checked the memory in the router and it says it is 34mb. 16mb is allocated to the flash and i assume the remainder is seperated between the i/o and the memory. can i use commands such as memory-size iomem to 'borrow'...
thanks for the reply,i have been using a tftp server but the upload always fails because of the lack of memory. I am not confident about having to justify both an ip feature pack upgrade and a flash upgrade to my bosses just for a 2620 using an adsl ...
Many thanks for that,I can dial and authenticate with my isp ok now.i cannot however surf the web at the moment. Do i need to enter some extra information , i.e. dns servers and the like? What should i set my internet explorer settings to also ?thank...
