Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am migrating from a CSS environment to an ACE module in a 6513. I have an ACE context between VLAN29 and VLAN30 that is a DMZ. VLAN29 faces the firewalls and VLAN30 the real servers. I can access the servers with a serverfarm and a "vip". I need to...
Your config looks ok. You still may not capture all the traffic. Here is why. When you capture with a VACL or a SPAN you usually capture both directions Rx and Tx. Gigabit is full duplex. You can send and receive 1Gpbs at the same time. Usually you d...
It is redundant, I put that in before the default, and never took it out.I found the problem. I had a load balance config for the firewalls and had applied it to the both interfaces. It only need to be on the vlan30 interface. I think I copied this f...
no joy.route table:ACE-6513-1/DMZ# sh ip roRouting Table for Context DMZ (RouteId 1) Codes: H - host, I - interface S - static, N - nat A - need arp resolve, E - ecmpDestination Gateway Interface ...
