Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Everyone,We have an existing Wireless Controller(AIR-CT5508-K9) in one of our Data center and this controller services 60 AP spreadout accross six different sites/ offices.Note that the existing data center where the controller is located will be ...
@JPavonM @marce1000 @Rich R , Appreciate all your feedback from all my previous inquiries. Just a quick question though about this commands;1. AP#capwap ap controller ip address x.x.x.x and 2. AP#capwap ap primary-base WLC x.x.x.xDo both of this com...
@Rich R What if I will just set up another Controller hosted in a different location. Copy paste the configuration from the existing controller except it's IP address. Please note that the new controller will have the same connectivity to existing AP...
@JPavonM @Rich R @Mark Elsen . I've read an article where in to enable HA, both controllers redundancy port and redundancy management interfaces must be configured in the same subnet. My question is, is it possible to have different subnets for redun...
Hi @JPavonM ,I tried to use the new radius server but users were unable to connect and is giving them an error "can't connect to the network". I did ran a debug from the controller and it seems the request from the user was picked up by the controll...
