Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear Community,We are trying to get Radius authentication to work for one of our ASA´s.It is working for every ASA except ASA1.following structure is given:ASA1:GigabitEthernet0/1nameif transfer-ASA1-ASA2security-level 10ip address 194.1.1.1 255.255....
Hello,we would like to access ASA1`s management01 Interface IP (192.168.4.1) from a host behind ASA4´s Interface GigabitEthernet0/1.1 via ASDM.The flow is SRC: 10.10.10.5 DST: 192.168.4.1 Port: 443 & 22 (ASA4 > ASA3 > ASA2 > ASA1)On ASA1 in the pack...
Hello together,I am trying to access our ASA via ASDM from another Interface than the Management Interface.I have multiple subinterfaces and I would like to access from one Host (Host A) behind Interface "test01" to the ASA via ASDM:GigabitEthernet0/...
Hello Together,
first of all the Setup we are using:
Cisco ASA ASA5512 Software Version 9.4(3)8 (ASDM 761)
AnyConnect 3.0.11042
Certificate and AAA authentification
If I store the AnyConnect- Profile manually to this location "C:\ProgramData\Cisc...
@Ruben Cocheno thanks for your answer.So you mean traffic should exit and come back via external ASA1: GigabitEthernet0/1 or new Radius host should be placed behind Interface at ASA1?
Hello,Yes it is added with IP 192.168.4.1 as a Client. If this would not be correct then I think I will not get "login OK" on Radius.If typing in a wrong password the Radius is saying "incorrect password".Below you can find the capture:3 19.909666 19...
Hi,thanks for all your effort As a workaround we did now the following:- created a NAT on ASA4 so that traffic to 192.168.4.1 will be translated to public IP- permit ASDM/SSH traffic for IP on ASA1With that traffic flow is no longer via ASA4 <transf...
Result of the command: "show route | inc 10.3.50.0"The command has been sent to the device######################################################################################Result of the command: "show route management-only"Routing Table: mgmt-onl...
