Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hey guys, I have this AP and I can't login on it after performing a full factory reset.
I'm not able to write anything when it finishes the boot and I receive the "user access verification" message.
After that these messages start in loop (wired0 ema...
Hi,
It established speed an duplex normally, I don't see any errors and the AP is visible with CDP
Switch#sh interfaces g1/0/9GigabitEthernet1/0/9 is up, line protocol is up (connected)Hardware is Gigabit Ethernet, address is 8c94.xxxx.xxxx (bia ...
The AP won't get IP. I'm using a switch that isn't in my network just to use the PoE and configure a static ip address of my access point management range.This AP was in my network working fine, and after the factory reset these messages starts.
