Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have a strange issue with some new switches trying to authenticate wired users using 802.1x.The new switches are 3 x C9200L-48PXG in a stack running IOS-XE 17.6.5RADIUS is setup to use ISE 3.2, which is working with our existing switches.The exist...
Afternoon AllThe issue now appears to be solved after the switches were transferred to the new office.No config was change between it not working before the move and working after being setup again.Seems similar to this other thread, although we had ...
I tried using the endpoint debug but it didn't seem to work, showed zero packets for any client I tried. Help for that feature was hard to find but I read something about posture being needed for it, which we don't use.I've collected packet capture o...
Thanks for the suggestions.PEAP did at least get denied by the default authorisation policy, but I didn't get enough time to setup the policy for a proper test. We're in the midst of moving office (where these switches are going) so had to do some wo...
Thanks BalajiUnfortunately we've looked at those posts before and didn't help. Although we haven't tried 17.9.X, we did try 17.11.X which had the same issue.The endpoints are connecting fine on the existing network, so assuming it is something to do ...
