Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have a problem with Cisco ISE 2.7 guest access. I can see in live logs that clients have been authenticated correctly but after every successful authentication ISE sending a CoA-request for reauthentication. This is happening every 5 seconds and...
Hi,I have eth0 configured for Radius and eth1 configured for Guest Portal access. The defualt gateway is configured for the same subnet as eth0. Eth1 is configured with and IP in the Guest subnet and I have configured an ip route for this subnet. My ...
Yes ISE is defined as Dynamic Authorization server on IAP. We have seen that the problem only exists when clients using an BYOD MAC-group in ISE (still using guest wifi), but when clients using Guest Portal on ISE it works fine. Check my Authorizatio...
Doesn't see any interesting in the TCP dumps. Yes I had accounting ON at the Aruba SSID configuration. I turned it off now and I it seems to be better. But the problem with connect/disconnect still exists of course.
yes I am using the custom Aruba network profile in ISE, we are using IAP without controller or Aruba Central, just virtual controller on the APs with AOS8. The clients flapping between connected/disconnected constantly after the first successful port...
Ok I see,But we still have problem with clients that constantly being connect and disconnected from the guest wifi every 5-10 second (same time as the CoA-requests). Do you think this is an ISE problem or Aruba problem?
