Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Afternoon,Is anyone aware of how https and console idle timeouts can be configured via FDM.I'm aware it may have to be flexconfig however commands beginning with http are showing as prohibited. Thanks.
Morning,Im having an issue with ZBF. It needs to allow the guest zone to the inside zone to allow the guest zone to redirect to Cisco ISE webauthentication, which doesn't seem to work. Anyone any ideas? Config below:Guest Interface:interface Gigabit...
Hi,I have a NIC team setup on widows with LACP enabled. Switch side, have a vPC setup on 2X Nexus 3K, set to trunk. vPC is up and status is good. Windows side status is also good.When pinging Nexus 2 from the server, connectivity is there, howeve...
Hi,Thanks for the info. I've actually managed to resolve this by amending the guest-to-inside and inside-to-guest policy maps to a state of pass rather than inspect. Not entirely sure why that has resolved the issue, and why inspect wasn't stateful...
HiThis isn't really practice as the whole idea is that customer and guest areon separate vrf. And guest traffic locally breaks out for internet on therouter. Where as the customer vrf internet goes via the data center.
Interestingly, I did some further debugging on this, and it shows packets being dropped arriving on the tunnel interface (inside zone) destined for the guest zone. However it's showing the source as the remote tunnel endpoint rather than the origina...
