Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,we plan to migrate legacy network to ACI,and will have an L2 trunk vpc link from ACI to Legacy.my question :- which is the best practice to configure that L2trunk interface ? Extend EPG or L2out?- do I need to enable spanning-tree bpdu filter on t...
Hi, we have plan to migrate legacy Server Farm to ACI Multipod, legacy design have transparent firewall between Server Farm Switch and Core Switch, All Firewall configured as transparent and Standalone, (all active without cluster) route manipulate b...
Hi,
I will move server farm from legacy network to ACI,
I have concern about the loop, when migrating blade servers that have switches.
here the scenario:
1. I've moved vlan 10 (EPG A) to ACI, but there are still some servers that are on the N7...
Hi,
Can i make trunk native port on ACI ?
I have a connection problem between leaf with autonomous Access Point.
How can i make a configuration like this in ACI ?
switchport trunk native vlan 10 switchport trunk allowed vlan 10,20 switchport mode tr...
Hi,
there is no firewall in between.
admin@APIC-01:~> ntpq -pcrv
remote refid st t when poll reach delay offset jitter
==============================================================================
10.2.35.150 .INIT. ...
Hi Alex,
here the output,
Leaf-201# show ntp statistics peer ipaddr 10.2.35.150
remote host: 10.2.35.150
local interface: Unresolved
time last received: 29s
time until next send: 35s
reachability change: 73032s
packets sent: ...
Hi,
it's been more than a week after I upgraded, and the error is still there.is there anything I can do to verify or to troubleshoot this issue?
and besides upgrading, I also imported configuration from ftp.
thanks
Hi manuel,
thank u for your response,
I have checked the switch brocade configuration, both uplink send traffic vlan differently, and each EPG using different BD. so, is this scenario loops free ?
and other question, should I enable MCP on that lin...
