Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello One More Time Community.I have a problem with data interface and cann't resolve it: I have an error like this Gateway cannot be reached through port Ethernet1/1 named “outside". My configuratiion: > show ip
System IP Addresses:
Interface ...
Hello evryone! Need Help!I have already configured my FP 1120 via Firepower Device Manager - all is Ok. But after some times I receive error: On mai window of ftd my ISP icon is grey and NTP Service doesn't work - also grey! I know that there is an e...
Hello I have very interesting problem. After some changes I cann't login into my FDM FP 1120 on 192.168.1.1. The FP configured as Router and enabled DHCP for clients - for all clients FP 1120 as Gateway 192.168.1.1. For now I can login only via Conso...
Hello Cisco's Community.
I have next configuration. I am using FP 1120 as router and firewall for my Netwrok. I configured Bridge Group for my interfaces on FP 1120 via Firepower Device Manager. All my clients receive IPs vid DHPC
192.168.1.0/24
I w...
I am change, BUT any result, still the same issues. One more whe I set management interface use this command configure network ipv4 dhcp-dp-route and set Configuration for Management interface to DHCP, I can run ping system 8.8.8.8 and All is Work, B...
Ok, BUT There is no any selection of interface, where I must to select interface, and One More I configure my FP vid FDM not FMC!In this situation what I must to select ?
Yes I am use this configuration beacause I haven't ANY seperate network or cabel for management interface: I want to use only data interface, I don't have another cabel for Management interface!
