Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Greetings everyone,
I'm seeking clarification on the functioning of OSPF in relation to sub-interfaces within a single router.
In my current setup, the physical interfaces are associated with the
192.168.1.0/24
network, while the sub-interfaces fall ...
Hello everyone, I am currently experiencing difficulties configuring OSPF using 4 VRFs in a circular/ring network using only one physical router. The problem lies in the fact that I am unable to configure IP routing on the LAN subinterface.This is my...
Hi everyone,I would like to configure a specific OSPF route in my router. I want it to take precedence over a better static route or a route with a lower administrative distance. Is there any way to achieve this?Any help would be greatly appreciated....
Hello everyone, while configuring RIP in VRF, I encountered a problem where RIP is configured, but it's not showing in the database (completely empty).Here's my configuration:router ripversion 2network 192.168.1.0!address-family ipv4 vrf redredistrib...
Hello everyone, I'm having a problem dealing with the following error while configuring BGP on 2 VRFs (Regular BGP, not MP-BGP).Please refer to the picture below.and this is my bgp configuration:!router bgp 65000no synchronizationno bgp log-neighbor-...
Hello and thank you for the response.
Yet assigning
10.0.1.10
for each VLAN doesn't work and will result in false connectivity tests when pinging the sub-interfaces.
On the other hand, the issue isn't about understanding whether i can put it or not, ...
I think my question has been a bit misunderstood, as all the replies have been about only two VRFs. I would like to share the picture below to clarify the situation.If we assume that each router represents a VRF, and all these VRFs are within a singl...
I have created two additional VRFs, Cyan (instead of Blue) and Scarlett (instead of Red). I am using a 4-pair RJ45 Ethernet cable to connect the two physical interfaces, but I am currently facing difficulties in understanding how OSPF will function i...
The goal is to configure a network with three routes: one specific route (10.5.0.0/16), one global route (10.5.0.0/24), and a third route (10.5.1.0/24). The objective is to observe the behavior in the routing table regardless of the routing protocol ...
