Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
In my lab i'm trying to ping a destination which is behind the zone customer by keeping source as zone inside which is configured on the cisco interface In simple language i'm keeping source as ip address configured on cisco asa interface (on inside ...
Can i use MED in above case to influence inbound traffic.R1 & R2 are advertising same prefixes to three different ISPs.Outbound traffic is influence by local preference.
aaa new-modelaaa local authentication attempts max-fail 6aaa group server tacacs+ ISE_GROUPserver name TACACS_ISE_SPserver name TACACS_ISE_PDserver name TACACS_ISE_PRserver name TACACS_ISE_PUNEaaa authentication fail-message ^CCCCCCCCCCCLogin attempt...
Today we have got maintenance window to perform cisco 9500 ios upgradation which is configured in stackwise virtual.I have some doubts regarding IOS procedure for cisco 9500We are using the install mode for IOS upgradation.Thing is that i don't want ...
Currently we are planning to change the old core switch (6880) to new core switch (9500).Is there any tool that can convert the configuration to new IOS XE configuration.
Remember, MED is relevant when comparing routes from the same AS. If you want to consider MED across different ASes, use the always-compare-med command. Pls confirm
Remember, MED is relevant when comparing routes from the same AS. If you want to consider MED across different ASes, use the always-compare-med command.
Human ErrorConsole cable was connected to standby switch in stack.when i moved the cable to active it worked..No configuration changes were made.Thanks all for your support.
We did a debug today on switch & observed that the remote add was 192.168.1.5..Anybody has any idea why it is using.instead it should the command configured belowip source-interface tacas vlan 199vlan 199 ip addr is 172.27.0.102
