Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have 2-3550's (EMI) with default routes of my 2 PIX firewalls (Failover) Connected to 2 T-1's. I need to make the two paths outbound load balance and redundant. These switches connect a switch that connectes to 2 2620's that have HSRP on 1 physical...
I'm trying to get access for a server (Webserv3) in a DMZ from the internet. This is the first server I'm trying to get to from the outside. Also I'm trying to limit some of the PC's on inside networks from the internet. I think the problem is with t...
Could someone explain the correct order to setup 2 3550 -24 EMI switches to connect to 2 2620 routers each going to the same ISP through different connections. Should I use EIGRP? What should I configure first? We are trying to: 1 Load balance outbo...
We are going to have a second T-1 installed using 2-2620 routers and 3 3550 switches and want to use both T-1's for 3 meg bandwidth. We would also like for 2 of the routers and 2 of the switches to back each other up. We have a checkpoint firewall th...
After trying this my self I ask Cisco:Can I add 2 static routes to load balance? Like this:static (inside,outside) XX.XXX.XX.35 netmask 255.255.255.255 1.0.0.0 netmask255.0.0.0 0 0static (inside,outside) XX.XXX.XX.34 netmask 255.255.255.255 1.0.0.0 n...
David,The idea here is to create redundancy with 2 two regular PIX if one fails there would be no firewall for the equipment behind it. Content balancing and IDS are in the near future. James
I realize we cannot load share between the PIX in failover but if a PIX fails I need the other one to take over for the failed one. So yes the load share is the primary concern. Both of the HSRP groups on the routers are from the same block of IP's w...
Just switching no with an IPaddress on vlan1 for access. So create a vlan for outside and connect the 2 PIX and the 2 Routers to it. Then add the 2 default routes on each PIX one for each HSRP???James
