Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
My 2600 powers on in a continuous boot loop with the following error:open: file "n" not foundopen(): Open Error = -1loadprog: error - on file openboot: cannot load "flash:n"I can only get it back on-line by going to ROMMON and typing in the following...
This happens on both type of reboots. On initial troubleshooting I tried the write erase and also adding the a boot statement to the config. Can you set any boot parameters in ROMMON?
