Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
For the life of me, I can't figure out what is causing my NAT problem. I ran a packet trace from 10.0.0.1 to 8.8.8.8 and received "(nat-xlate-failed)NAT failed" message. All I'm trying to do is to allow any host from 10.1.1.5 subnet to go out to the ...
I have never bond that many T1s in an office so I need a little help. One of our office currently have (4) T1s bonded together giving them 6 Mbps total bandwidth, we will be adding 3 additional T1s to the existing bundle that will give them a little ...
The outside interface is enabled but I keep getting the nat-xlate-failed message when I ran packet trace using asdm. Here's the trace from putty: packet input inside tcp 10.0.0.1 www 8.8.8.8 www Phase: 1Type: ROUTE-LOOKUPSubtype: inputResult: ALLOWCo...
Hi Peter,Thank you so much for your response.I was certain this is how the I should configure the additional T-1s, but wanted input from people with more experience than I am since I have never bonded that many T-1s together. I also was not sure how ...
