Hi,
I am working in a ISP company, I read that between PE routers should be always ibgp neighborship but in the Global VRF I can not see any bgp neighborship between PE routers only I can see IS-IS routing protocol.
can anyone explane me why i can no...
Hi,
I have two cedge router and I have configured VRRP in the service VPN (VRF 1) but the VRRP state of two router is master. I have pasted the configuration in below.
Router1:interface Vlan101vrf forwarding 1ip address 10.1.1.2 255.255.255.0no ip re...
Hi,
I would like to create a PBR and apply it to an interface. I have created the route policy below and also a localized policy. I added the route policy to the localized policy and finally included the localized policy in a device template. However...
Hi everyone,
Currently, I've been using the Interface NAT type for Direct Internet Access (DIA) across multiple networks.
However, I recently came across a Cisco article (Below link) suggesting the utilization of a Loopback interface for DIA ins...
I want to establish a centralized policy in SD-WAN to route traffic to a particular destination FQDN. I understand that in vManage, there are Custom Applications that allow me to define specific FQDNs or applications. However, when attempting to crea...