Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, I hope everyone is healthy.I recently started learn about Cisco and installing CSE-LABVM onto Virtual Machine.Is there a way i can install it on my bare metal? Thank you very much.
Hello guys, I need to create 5 Router with 1 Switch using VLAN and Access mode , everything should have connected and can be ping.I've try to searching with no success this is the layout, an example of full config is appreciated,
this was the up to date image with the ping log based on the guide on the link.the original question is :Please create a setup with 1 switch and 5 routers. One router should be the main router and have 4 VLANs with VLAN IDs 2 and higher. The rest of ...
hmm sorry, it still can't ping other router, it's same as before, all router 1-4 can ping to 0, but 1 to 2 or 1 to 4 cant, is it possible to make it work ? or perhaps i need ask more clue to my senior? maybe the question is not correct.
im following this guide https://www.routerfreak.com/router-on-a-stick-introduction-configuration/except the trunk, now every router can ping, this chatgpt make me want to leave learn about networking, really wasting my 6h. Thanks you very much to bot...
i may want to go for one router act as router in stickthis is the chatgpt asnwerRouter1 (Central Router - VLAN 2 as Main VLAN):
enable
configure terminal
interface FastEthernet0/0
no ip address
shutdown
exit
interface FastEthernet0/0.2
encapsulation...
