Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
What is peer gateway?Peer gateway is a feature which was developed to support network devices which use non-standard layer 2 packet forwarding in a vPC environment. This was first discovered by NetApp using the fastpath feature but other devices hav...
You are running a platform that there is no software workaround for the ShoreTel phones sending too much voltage. On the platforms where you can configure the command we are able to absorb some of the spike in voltage, but on the other platforms the...
(10.0.10.27, 225.0.0.17), 3d12h/00:03:23, flags: FT Incoming interface: Vlan20, RPF nbr 0.0.0.0, Registering (data-header)It looks like you are stuck in registering. Is there an RP defined for these groups? Is that RP allowed to be the RP for these...
ip route 0.0.0.0 0.0.0.0 GigabitEthernet1/0/1ip route 0.0.0.0 0.0.0.0 GigabitEthernet1/0/12 2ip route 10.3.0.50 255.255.255.255 GigabitEthernet1/0/5ip route 10.40.8.0 255.255.255.0 GigabitEthernet1/0/5These routes are all going to have a better metri...
It would look like this:ip route 0.0.0.0 0.0.0.0 10.3.0.5ip route 10.40.4.0 255.255.255.128 10.3.0.14Most likely the main culprit here though is the default routes. Were you getting a default route through eigrp before?-Matt
You have the following in your configuration:ip route 0.0.0.0 0.0.0.0 GigabitEthernet1/0/1ip route 0.0.0.0 0.0.0.0 GigabitEthernet1/0/12 2ip route 10.3.0.50 255.255.255.255 GigabitEthernet1/0/5ip route 10.3.0.54 255.255.255.255 GigabitEthernet1/0/5ip...
