Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hi alli have an etherchannel setup between 3550 and a 3548. in testing when i disconnect one of the links it takes close to 10 seconds for the other link to start transmitting data from the test machine. i have data going over both links at all tim...
helloi have been receiving a lot of crc errors on a fiber module port. i have replace the fiber patch cable and even went so far as to replace the 4 port fiber card. i can't get a handle on where they are coming from. the other end is connected t...
Being fairly new to networking and especially managing a pix firewall i have a question concerning a syslog message. we are running a pix 506e ver 6.1 and i have seen this message on a daily basis:%PIX-5-304001: 12.80.4.8 Accessed URL 12.29.188.41:/...
here are the interface configs:3548interface GigabitEthernet0/1 no ip address channel-group 1 mode desirable! interface GigabitEthernet0/2 no ip address channel-group 1 mode desirable! interface Vlan1 ip address 172.16.48.100 255.255....
yes i do have some spare dark fibers.....that was going to be my next step, but i wanted to make sure i wasn't overlooking something obvious before i go to the trouble of terminating the spare fiberthankssteve.
i havd checked that previously.....here is the other port:FastEthernet2/1 is up, line protocol is up Hardware is Fast Ethernet, address is 0090.f230.e2dd (bia 0090.f230.e2dd) MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec, rely 255/255, load 1/255 ...
