Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
For a new web server load balancing design, I need to load balance 4 web servers to start with and more in the future. Should I place the CSS in a DMZ and run a one arm config or have the web servers direct attached to the CSS in the DMZ and run anot...
Can anyone share if it is better to put a health probe under a real server or under the server farm. Is there is any advantage to either way? We are looking at doing a get url.thanks in advance
We have servers that establish a number of connections for a connection pool to the backend db's and the connections cease to function after a couple hours. We didnt have this problem until we moved the app into the csm vlan. I know the default for v...
We tried to one from Verisign and was told they dont this platform/cisco??!!Who has done this from where can we request a certificate from for this box
There is a brand new redbook from IBM on how to set up blade servers/ Blade Center with Cisco switches.http://www.redbooks.ibm.com/redpieces/pdfs/redp3660.pdf
I dont think you can change the port parameters - Connect a console to the Console port on the CSS. Configure the console withthe following default values: 9600 baud, no parity, 8 data bits, 1 stop bit, andflow control set to None. This is from the a...
Try doing a search on HSE on CCO or Hosting Solution Engineor start herehttp://www.cisco.com/en/US/customer/products/sw/cscowork/ps150/ps4862/index.htmlhttp://www.cisco.com/en/US/customer/products/sw/cscowork/ps150/prod_bulletin09186a008010e5ab.ht...
Server initiated connections don't hit a vserver. I would like to know what the timeout value is for tcp connections and/or udp for real servers that initiated connections out and if it is adjustable.
