Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Cisco AP led blinks cycling: Red - Green - BlueBut it seems I do not have any issues with power:WiFi SSID was searched/scanned with a few phones and laptops, none of them could see SSID.
Does I must use AIR-PWRINJ6?Is AIR-PWRINJ4 doesn't support AP 2800?From power injectors specifications I can see that both AIR-PWRINJ4 and AIR-PWRINJ6 do support 802.3at (30 W) and 802.3af (15.4 W).
Access point has been powered up for over an hour.Power status didn't change, it's "Power injector / Full Power" Cisco AP: AIR-AP2802I-B-K9Cisco power injector: AIR-PWRINJ4
