About MBCChris

MBCChris · 09-19-2023

Hello, I need some help.One of our 9200L has been reset with a factory-reset all command. It will now only boot into rommon.I have tried various ways to restore the ISO. I have downloaded the latest cat9k….bin file from the website and copied it to a...

MBCChris · 09-21-2023

Hi Leo,I tried the tftp thing you mentioned a few post ago, just incase I was wrong. And it worked I had to mess around with boot loads but my switch now boots. Thank you so much for you help and patience.

MBCChris · 09-21-2023

If I boot off the usb I get Switch#sh run int vlan1Building configuration...Current configuration : 38 bytes!interface Vlan1no ip addressenddo you think it is worth trying the tftp install to the usb drive?

MBCChris · 09-21-2023

I did try that but when I tried to set the ip address i get the error “Can't set variable "IP_ADDRESS.....". I am starting to wonder if the switch is faulty in someway, it should not be this hard to flash on a new os

MBCChris · 09-21-2023

no options it just makes an error noise

MBCChris · 09-21-2023

Switch#sh postStored system POST messages:Switch 1---------POST: CRYPTO Tests : BeginPOST: CRYPTO Tests : End, Status PassedPOST: PORT Loopback: loopback Test : BeginPOST: PORT Loopback: loopback Test : End, Status PassedPOST: SIF Tests : BeginPOST: ...

Member Since	‎09-19-2023 02:37 AM
Date Last Visited	‎10-16-2024 07:29 AM
Posts	12

User Statistics

User Activity

Restoring iso to a 9200L

Re: Restoring iso to a 9200L

Re: Restoring iso to a 9200L

Re: Restoring iso to a 9200L

Re: Restoring iso to a 9200L

Re: Restoring iso to a 9200L