Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello i currently have this small setup. i have configured ip routing on the L3's and want to use those as gateways on the PC's and then have them send the data to the router.
Right now the PC's send their data to the HSRP standby IP i've setup be...
Hello admins.I have been struggeling with a network setup for some time now and i think i've gotten close to getting it done (thanks to help from many of you guys)however i'm currently stuck on a new hurdle.In the topology above i've decided to cut o...
Hello, So i'm doing an assignment and i'm interested in doing a routing setup with OSPF on my Layer 3 switches.I would want to have my layer 3 switches route all the traffic that's supposed to go outside to the closest firewall interface.However i am...
Hello.so i'm in the middle of an assignment and i've started getting MAC flapping on my port channels.i cannot for the life of me figure out how to get it to stop.most of what i've read is to setup spanning tree, but i'm not sure exactly how to do th...
Hello.i'm trying to setup some subinterfaces the following wayInterface GigabitEthernet1/7.2Vlan 2192.168.2.1Interface GigabitEthernet 1/8.2Vlan 2192.168.2.1how ever it doesn't allow me to put vlan 2 on the 1/8.2 subinterface "ERROR: Vlan 2 exists in...
In router config static route toward VIP of HSRPso i should set a static route that anything that needs to go to vlan 1 gets sent to the vlan 1 HSRP IP
(ip route x.x.x.xip of other network on the other bgp x.x.x.xhsrp ip
so set an ip on the 2 interfa...
when you say default route towards your isp,we have 2 available public IP's for this project do i just choose one of those and make the default route towards that.and am i supposed to set said public ip on our Firewall interface 1/1 that goes from th...
