About ken_nguyen

ken_nguyen · 11-17-2008

Hi, I'm trying to configure my 4 port IPS, and am running into some peculiar situations that I can't seem to find resolution on.I want to dedicate 2 of the 4 ports for iSCSI and the other 2 for FCIP. I'd like to bond 2 ports to support one IP addr, ...

ken_nguyen · 11-05-2008

I'm cleaning up an environment that I inherited, and the VSAN ID's have no reasoning behind them. I'd like to clean it up, and establish a standard across all of our sites, as our next project will be FCIP. While we will be implementing IVR NAT, I'...

ken_nguyen · 11-19-2008

Ok, while I'm not sure if we can etherchannel the physical adjacent ports, it looks like you can port channel the fcip connections.I haven't configured iSCSI yet, so we'll see if it works the same way.

ken_nguyen · 11-19-2008

Mike, Thanks for the response.Do you know if the IPS-4 GE ports support EtherChannel? If it does, I can't find any documentation on it.If it is, would you mind pointing me in the right direction?

ken_nguyen · 11-06-2008

inch-That's what I've done, created a new VSAN, and copied the zone db over, and activated it, then changed port memberships to the new zone.I was hoping there was an easy method, but since VSAN are based on physical ports, I guess this is my only ch...

Member Since	‎11-05-2008 05:02 PM
Date Last Visited	‎08-18-2017 03:54 AM
Posts	5

User Statistics

User Activity

MDS 9222i IPS configuration

Is there a way to change the VSAN ID?

Re: MDS 9222i IPS configuration

Re: MDS 9222i IPS configuration

Re: Is there a way to change the VSAN ID?