Need some help with 9300 Static Routing.
We have a stacked 9300 being used as a collasped core with all of our VLANS on it. Each VLAN has an SVI and IP routing is enabled. We also have a gateway of last resort set of the firewall that is connected...
I am running ip routing on the switch.
9300L_Core#sh run | include ip routingip routing9300L_Core#sh run | include ip routeip route 0.0.0.0 0.0.0.0 192.168.200.2549300L_Core#
Each VLAN has an SVI attached to it.
For Transit VLAN, how do I config...
So you think the issue is the firewall? Right now it only has a gateway of last resort for 0.0.0.0 to the ISP Public IP. The firewall is Fortinet so I can reach out to their support if you feel it is needed. Just wanted to make sure the Cisco port...
The firewall is 192.168.200.254. I can only reach it from VLAN 200. All rules are set to allow ALL just to get this setup and going.
9300L_Core#ping 8.8.8.8Type escape sequence to abort.Sending 5, 100-byte ICMP Echos to 8.8.8.8, timeout is 2 seco...
