Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Experts,I have a peculiar problem. the scenario is this. I am building two different VPN tunnels from two different Accenture Locations to my client's network. Both the VPN Tunnels are terminated in the same ASA 5520 at the Client end. The source ...
Hi Experts,i have a situation where I need to configure forwarding between two VPN Tunnels terminated in the same ASA box. One VPN Tunnel will carry the incoming traffic and this traffic needs to be sent down the other VPN Tunnel in the ASA. Both the...
Hi Experts,I am working on establishing a connectivity for one of our clients. I have built an IPSec VPN Tunnel between our office and Client's office. However, i need to do many to one translations of the client's private IP addresses which will be ...
As a Technology implementor in my organization, i have a necessity of implementing Multiple IPSec VPN Tunnels to a single Remote site, say between Point A and Point B i need to have more than one IPSec VPN tunnels. My criteria is i have only one inte...
i was wrong...it indeed was working...i was attempting to ping the gateway IP of PC1 from PC2 and vice-versa which is NOT working though..but my attempt to ping PC1 from PC2 and vice-vera was successful...thanks to all experts for their suggestions!!...
inter-vlan routing in PIX/ASA is not working as it is intended to...i believe PIX/ASA have an L3 engine which takes care of this routing stuff (as otherwise, it would not have support for RIP and OSPF in v7.2)...but for some reasons, i am not able to...
sorry for the confusion...let me try to clear it...You are correct in your understanding...the Cisco ASA will only be the Hub...it will not have neither of the subnets locally...and i am just trying to pass the traffic from Tunnel A to Tunnel B...Poi...
how about this configuration for the scenario in question...In the Cisco ASA where both the VPNs terminate..interface G0/0name Untrustip address 170.252.100.20 255.255.255.248crypto map pointAToCiscoASA_Traffic extended permit ip 10.1.1.0 255.255.255...
Hi Jon,thanks for your reply to this thread...that cleared my doubt too...is it also possible to use policy based NAT in this scenario... say i have three different subnets as sourcesource1 = 10.0.0.0/8source2 = 172.16.0.0/16source3 = 172.28.0.0/16de...
