Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have the management address of 192.168.1.1 on my asa5510 and an address of 192.168.1.2 on the ssm-10.Both the mangement of the asa and the ssm-10 are plugged into my switch. I can access the adsm and manage my asa but cannot access the ssm-10 from ...
I have an AIP SSM 10 module on an ASA 5510. My management address of the ASA is still default at 192.168.1.1 and the management of the IPS is 192.168.1.2.Internal addresses are 172.16.x.x, external addresses are 10.1.x.xI would like to setup the SSM ...
Pretty new with the ASA 5510 and I cannot seem to find any info on security levels.I have an outside interface set at security level 0, the inside interface at 100, and the E:2 which will be the DMZ, I am not sure what to set the security level to. ...
Got it!DOH!I had a route on my laptop 192.168.1.6 255.255.255.255 192.168.1.1When atttempting to connect, the data would go to the firewall management port and attempt to then connect to the ssm-10 at 192.168.1.6.I deleted the route and Shazzam, a co...
the 192.168.1.2 is the asa management address, the 192.168.1.6 is the IPS management address. Both management ports and my computer are connected to the same switch.I sessioned into the IDS from the CLI and added my computers address of 192.168.1.4 t...
Ok,I connected to the ssm via the CLI and sessioned in using session 1.I added my address of 192.168.1.4/32 to the access list.I am now getting the following error:through the device packet to/from management-only network is denied tcp:src management...
Not sure how to even respond, I am by no means a firewall guru.There are no static routes from the mangement port of the firewall to the ssm. guess that needs to happen.Can I connect directly to the ssm-10 via ethernet to the management port and open...
