Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all. I'm pretty new to Cisco, and need to setup VPN access on a newly purchased 1811w router. Basically I need a setup where company employees can access their work desktop from home.I have followed the instructions found here:http://cisco.com/e...
A few days ago, the SDM was up and working. However, I was having trouble getting the router to connect to a TFTP server, so I used the SDM to upload a config file to the router. The result was all the data on the flash card becoming corrupted.So I...
Hi all. I am having trouble restricting communication between 2 VLAN's via ACL's. What I am trying to do is configure an ACL that allows VLAN-3 (10.10.30.0) to only be able to talk to 3 specific hosts on VLAN-2 (i.e. 10.10.20.15 - 10.10.20.17).If I...
Hi all,My company has recently purchased a Cisco 1811w security router, and the responsibility of getting it up and running (and getting a new network scheme up and running for that matter) has been placed in my lap. While I did take a few networkin...
Thanks for the help Jon, and the explanation. I think I was just pinging the router too quickly (within 30 seconds) after I uploaded the config file. Everything seems to be working now.
Ok, it is working, somewhat...Sending a ping to .15 .16 or .17 works as expected. Sending a ping to a host that should not be allowed to communicate responds as follows:#1 Ping from 10.10.30.4 to 10.10.20.9:Reply from 10.10.20.9: bytes=32 time=3ms T...
Do you have a layer 3 switch that you're connecting the router to?1. Do you know how to get into the router? 2. Will you be using NAT? 3. Do you have public addresses for your internet connection, or are they being assigned? 4. What kind of internet ...
