Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
In the build process, we initially configured the Guest Wireless settings (Security: Open).Provisioned the Fabric and assigned Wireless SSID's to Address Pools (Provision > Fabric > Fabric Site > Host Onboarding > Wireless SSID's)We conducted testing...
Does/will Embedded Wireless Controller on 9500 switches (co-located Border-Control-EWC) for an SD-Access Fabric-Enabled site support high availability?Not just some floors on one 9500 with some floors on the other 9500, I mean Access Point and client...
Unable to enable the Embedded WLC on 9500's (Border Nodes) via DNAC.It is stuck in the "Image imported successfully" state and will not progress to the “Image activation” stateI have followed the following guide:https://www.cisco.com/c/dam/en/us/td/d...
LAN Automation Failing due to PnP ErrorState: ErrorOnboarding State: Connection ErrorHistory Details: NCOB02068: Certificate is not valid (ip/host name does not the match the Common Name or Subject Alternative Name): SSL Server ID check failed after ...
The Map Information and Calibration Information can be Exported from Cisco Prime Infrastructure and Imported into Cisco DNA Center, but can the Calibration be performed on DNA Center without needing Prime?
I was under the impression once a device had been Provisioned in the Fabric, all other “Provisioning” changes were to be done by DNAC via “Provision > Fabric > Fabric Site …” (which I was obviously wrong ).I have just done a re-provision on the 9500...
I have a Cisco "SDA Design Training (1.3.0)" slide deck which shows 2 distinctly separate (not stacked) switches labelled as "Embedded Wireless C9k Switch" with the following statements:"Robust HA""Supports 200 APs and 4000 Clients per Site with HA""...
If your company is like mine, my new laptop is totally locked down so I can not transfer a file using the traditional means (TFTP, FTP, SFTP, SCP).So I had to use HTTPS. Config added to switch:ip http serverip http secure-serverip http authentication...
Hi @palonso_3 , I am experiencing the same issue and have attempted the "workaround" in the bug description, however, still stuck in the same place.Your steps are different to the bug workaround steps, namely "Upload WLC package to device and activat...
