Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, all!I have enabled SVI counters using 'hardware profile svi-and-si flex-stats-enable' command in N9K-C93180YC-EX switch.The question is: does L3 traffic within same SVI between primary and secondary subnet counts?
Hello community!I have two 93180YC-EX in VPC, NX-OS mode: BIOS: version 07.66
NXOS: version 7.0(3)I7(9) Sometimes we experience unknown unicast flood for ~1-3min due to disappeared MAC. This situation arises every several hours randomly. At the time...
I have found the problem. I forgot to enable portfast for several access switches connected to my VPC pair. Thus a STP TCN was occurring in the VLAN when these access ports upped or downed/upped causing rebuilding MAC table.Thank again to all partici...
Thanks for your suggestions. I'll investigate the MAC situation further and keep you updated. As for aging, i have defaults on both switches: 1800 (MAC) > 1500 (ARP), so there shouldn't be issues, i think.
nothing suspicious here also: # show vpc consistency-parameters vpc 1
Legend:
Type 1 : vPC will be suspended in case of mismatch
Name Type Local Value Peer Value
------------- ---- -----...
primary:# show vpc
Legend:
(*) - local vPC is down, forwarding via vPC peer-link
vPC domain id : 1
Peer status : peer adjacency formed ok
vPC keep-alive status : peer is alive
Con...
