Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I've used the following to pull in contact information for approvals / tasks after the fact. You need to replace [RequisitionID] and [TaskName] with the appropriate values for your request. If you only want e-mail address, you can pull out the DirPer...
I've taken a two-tier approach that has thus far been very successful in keeping our implementation of RequestCenter highly available. Experience has shown that server monitoring is absolutely necessary, but in and of itself isn't a sufficient soluti...
If this is an installation using IIS: On your Web Server check the configuration for the actual site and ensure that "Integrated Windows Authentication IS checked" and that enable anonymous access is NOT checked. You may also need to ensure that the ...
Your best practice in this instance depends a bit on how much work you want to put into it at the front end and how tied to the idea of a direct link to a service you are. If your team uses a decent build sheet and migration checklist then updating t...
I've had a comparable requirement in the past and have used a similar "trick" to implement this type of functionality. In my case I created a table in a database that I would populate using the DB adapter. I then developed a VBScript to poll this tab...
