Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We currently have a client using 2x4402 WLC's, with 2xRAP(1520AG's),1MAP1(1520AG), 1 WGB(1310G) and 2xCCTV(AXIS) camera'sconnected to each of the MAP1 & WGB. we are using WLC Software code ver.5.2.157 for the 2 WLC'sScenario1: WLC(1/2)---SW---RAP1==...
Hi Nagendra,We are using an Axis 214 PTZ Network Camera, with static ip on the camera. We waited for quite some time about 2 minutes, when the RAP & MAP is able to failover together to the WLC.Is it sufficient time to wait? More than that would not b...
Hi Nagendra,Thanks for your reply, the MAP PoE port is configured as Access Vlan 28, that is directly connected to Camera 13.The checking and unchecking of the Checkbox for the Vlan Transparent is the Workaround to bring back the Camera 13.Hoping you...
Hi Naks,Thanks for your prompt response on my Failover case, As per your comments, Yes we did configure the RAP port connected to the switch with a trunk native vlan 4 and trunk allow vlan 4, 28.I understand clearly that you need to disable the Vlan...
Hello,We are also encountering a problem with vlan tagging on Ethernet Bridging on the RAP and MAP(vlan 4,Mgt Vlan), we are currently using 5.2.157 software codes for the 2x WLC's and when we Failover to the WLC2, it seems the client with a different...
Thanks htarra for the write-ups above. appreciate it. The uplink of the switch to the controller is already configured as a trunk port with a native vlan set as 3 on the switchport, allowing also the vlan's needed to pass through(Clients & CCTV). And...
