Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I m using one 1522 AP as a RAP and one 1522 AP as a MAP.Also there are four 1242 RAP Aps.1522 AP could find its 1522 RAP earlier before connecting 1242 RAPs in network but after connecting 1242 RAP APs the mesh 1522 AP disappars after few menutes ...
Hi,I tried all these possibilities before only so many times but doesn't work.Also checked with clearing the Aps.1242 RAP APs can join the WLC but they cannot detect any of the 1522 APs may be because of regulatory domain not supported for 802.11a ra...
802.11a interface on the RAP is steady and there are no interference issues as well.Power settings to the MAP is absolutely fine.We didn't make any changes to existing setup after connecting 1242 RAPs.We just connected 1242 APs and configured them as...
Hi,1522 MAP joins 1522RAP only after I restart the 1522RAP ap but just for a min or two.Without doing this MAP never detects RAP.It was working fine before connecting 1242 RAP aps.1.WLC Software Version 4.1.191.24M (Mesh) 2.Name of 1522MAP is 'MAP-AI...
HiI have added the mac addresses of RAP and MAP in controller.Mesh mode is also configured properly.Default Bridge Data Rate for RAP and MAP is 24 mbps.I tried changing that also but couldn't solve the problem.Link SNR between RAP and MAP is 23db and...
