Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello everyone,We are running an ISA 3000 firewall currently imaged with FTD firmware version 7.4.2.3-4. The firewall is a single stand alone device, managed through FDM. We do not have FMC.Cisco has updated their "Golden Standard" version recently t...
I manage an ISA 3000 firewall running FTD 7.4.2.3-4 using the FDM. This is for a small site with just this one firewall. There is no FMC and we do not want FMC. The device will be managed through FDM. We have all the NGFW licenses for the FTD (IPS/ID...
Hi all,We are running an ASA 5512-X firewall running firmware version 9.12.4(62) from September 2023. It is end-of-life and will be replaced in the next few months. Until then I have to make do with this firewall.We are using AnyConnect, or in this c...
This is the output of the command on the coreswitch:Flags: D - down P - bundled in port-channel
I - stand-alone s - suspended
H - Hot-standby (LACP only)
R - Layer3 S - Layer2
U - in use N - not in us...
The only problem is that all of our sub-interfaces, ACLs, NAT rules, VPNs etc. etc. are all tied to this etherchannel. So if I need to undo the etherchannel configuration it is going to error out saying there is other configuration dependent on it. S...
Hi Marvin,Please disregard. I found my own mistake. I recently changed the gateway for the management interface and I punched in the wrong IP address. After updating it to the correct one the URL filtering now seems to be working.One thing I do want ...
@tvotna Gotcha. Thanks a lot! To confirm, I no longer see authentication rejects on the LOCAL database, so that all seems to work. I was just worried if the "authentication certificate" would open up other security holes. But yes like you said, its n...
