Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello all,We (my team) are dealing with NAT configuration everyday, on Cisco routers and firewalls.The following document "NAT order of operation" is very useful, and we have been looking for a long time to the same document for ASA and PIX firewalls...
Hello,I'm looking for a way to do PAT from an outside to an inside interface, on a 2811 router running IOS 12.4I've checked the documentation and only found information for PAT from inside to outside, but it is not clearly said that we can't do it on...
Hi t4tauseef33,No, I did not find any solution.What proposes Jon works but, in my case, I can't use private addresses. I can only use one public address...The only solution I found is to reverse the NAT (outside->inside changed to inside->outside)
Hi Jon,Thanks for your answer.If I understand correctly, you propose a NAT solution, and not a PAT solution.That means my pool must contains as many addresses as the number of source IP to NAT. Is that right?Regarding my needs, many people, from a cu...
