Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I need to configure my Cisco877 just in bridge mode between ATM interface and interface VLAN1 so my PC would get public ISP IP address. I think this is done just setting my windows xp network interface for DHCP client. Could anyone send me or post th...
Thank you very much for your reply.I was thinking the same answer. Just wanted to know if there was another possibility.Your solution seems ok for me.Thanks again!Sebastian
It works!I tried this configuration this afternoon and it worked. I also defined DHCP client on my PC network card.You can have a look at it:Router#sh running-config Building configuration...Current configuration : 903 bytes!version 12.4no service pa...
