Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have 9 1010 AP's which all were just plugged in and auto configured themselves from the controller. We now need another AP so I was told that the 1131 was the replacement model. But I cannot for the life of me get it to be seen by the controller.....
The Cisco IOS DHCP server only allows Option 43 definitions for one device type for each DHCP address pool, so only one AP type can be supported for each DHCP address pool.
I changed the controller to layer 3 and all the exisiting ap's disappeared and did not come back and the 1131 still did not connect, with option 43 or manual settings......Why hae they changed the way they work...? Reading further you can only have o...
Ok, the ap was autonomous not lightweight, so change the firmware and it still does not auto connect to the controller as the 1010's do. So I tried the lwapp commands and the controller and 1131 can ping each other but it is still not addedd to the c...
